Lull 1044C-54

classifieds board First $26,000 takes it.    Many offers no buyers.    interested?  e-mail me. For sale is a very good condition  Lull  1044C-54 Rough Terrain Telescopic Forklift.  54 foot lift height and 10,000 pound lift capacity*.  It has the John Deere 4045T Four Cylinder Turbo Diesel Engine in it. Four wheel drive, four wheel steer.  It has 3 steering modes (front only, round and crab).  It has main frame tilt and fork frame tilt (left and right and front to back). 4 speed ZF transmission and ZF axles. Front outriggers. The machine has been cleaned and greased. New seat with seat belt.       Mechanic: front 2 outer top chains replaced, all  3  front top outer chains greased, boom chains adjusted, transfer carriage frame welded and plated under right hand rear tilt cylinder (see pic), all axles, hubs and transmission fluids are full as well as hydraulic fluid and coolant.      I replaced engine oil and filter, air filters, fuel filter, hydraulic return filter and tank breather, new battery, new alternator,  had right hand lift cylinder rod end repaired with machining and new bearing and pin, replaced seat, greased machine, cleaned, installed reflectors,  lubed boom and wear pads.     The machine has no major leaks and all functions work. The second Auxiliary system has been removed, so you can not install a tower on this machine without replacing some hydraulic lines. It has a removable fork frame, so you can install a bucket or platform with Lulls' quick disconnect frame.      The 4 Cylinder John Deere 4045T Turbo Diesel starts right up and has much power. It has a block heater. Everything else is the same as far as the typical John Deere 4045 engine goes. 7375 hours on the original meter.      It may need two hoses in the front carriage and one in the rear, but they are not leaking now. The coating is beginning to flake off. The back up alarm works and all boom functions too.  Comes with 2 tine forks.  These machines are getting harder and harder to find, especially in this condition at this price. Or you could buy a new 10k for about $90k. You could buy it and put a $5K 2 color paint job on it and sell it in the low 40's like the other guys. Or you could put a $3K one color paint job on it and sell for a profit or keep it for yourself.  Or you could buy it, not put anything into it except fuel and get to work making money and looking good doing it. You can add a cab enclosure, door and cab heat if you want to. Or fabricate one. *capacity diminishes as you extend outward. As do all telescopic forklifts.  See load chart in cab.  I can help arrange shipping and load machine. It is the buyer responsibility to obtain shipping and pay taxes. The machine is on Long Island, NYIf I don't get my price I'll relist it or I'll just bring it to the next job and sell it another timeEmail any questions before buying. I will answer all questions to the best of my ability.      A $500 non refundable immediate deposit is required for "buy it now" and any "accepted offer". Full payment is due within 5 days. I can hold the machine for 20 days after full payment without additional charges. After 90 days, the machine is considered abandoned and will be resold. Unless we have an agreement. Paypal can only be used for deposit. Balance must be made by money order, cash, bank check or wire transfer. No business or personal checks or credit cards. Nonpayment will result in negative feedbackIf you have less than 50 feedback score email me before buying or making an offerBy making an acceptable offer or clicking "buy it now" you are accepting these terms

Also published on classifieds board.