Hubtex DQ40/3050

WISCONSIN METALWORKING MACHINERYFOR MORE INFO, PHOTOS, AND VIDEO VISIT:HUBTEX SIDEWAYS FORKLIFTID#10138 Specifications: GENERAL SPECIFICATIONS: MANUFACTURER......................... HUBTEX MODEL................................ DQ40/3050 SERIAL NUMBER........................ 61.679 AGE.................................. 2008 NUMBER OF HOURS...................... 1500 CAPACITY............................. 10,000 LBS MAST    COLLAPSED HEIGHT.................. 109.4"    MAX. FORK HEIGHT.................. 199"    EXTENDED HEIGHT................... 259"    CARRIAGE HEIGHT................... 48" LOAD PICK-UP DEVICE    STANDARD CARRIAGE................. 49.2"    TWO FORKS......................... 1.9" X 6.9" X 47.2"    FORK ADJUSTMENT................... 19.7" - 49.2" MANUAL    HYDRAULIC FORK TILT............... +5 TO -3 DEGREES SPECIFIC DIMENSIONS    HEIGHT OVER CABIN................. 98.4"    TOTAL LENGTH...................... 87.4"    LOAD BED LENGTH................... 48"    FRAME WIDTH....................... 99.2"    MAST REACH........................ 49.2"    HEIGHT OVER LOAD ARM.............. 23.6"    LOAD ARM OPENING.................. 52.7"    DISTANCE OVER LOAD ARM............ 86.2"    GROUND CLEARANCE.................. 7.7"    RAMP CAPABILITY................... 12%EQUIPPED WITH: 3.0 GM INDUSTRIAL PROPANE ENGINE WITH SOUND PROOF AND REDUCED VIBRATION, 4 CYLINDER STRAIGHT TYPE 3.LITRE ENGINE ALL WHEEL DRIVE ALL THE TIME, WITH THE TIGHTEST STEERING IN CLASS, SMOOTHEST SPEED REGULATION IN CLASS, HIGH ENGINE TORQUE AT ALL SPEED RANGES, AND LOW NOISE LEVEL. HYDROSTATIC BRAKE THAT DOES GENTLE BRAKING WHEN THE DRIVE PEDAL IS RELEASED OR POWERFUL BRAKING BY USING THE BRAKE PEDAL. PARTIAL CABIN WITH HEATER AND DEFROST ELECTRONIC 3 WHEEL STEERING SINGLE LEVERS FOR LIFTING, LOWERING, MAST REACH, AND MAST RETRACT. JOYSTICK CONTROL OF DIRECTION.  *******NOTE VIDEO IS NOT OF THIS MACHINE, BUT THE SAME MODEL******* VIDEO OF THIS MACHINE IS AVAILABLE OR YOUR INSPECTION IS ENCOURAGED. SPECIFICATION SUBJECT TO VERIFICATION

CONDITIONS OF SALE

TERMS: Cash or check with order, unless otherwise stated. WARRANTY:  The goods described herein are pre-owned used goods and are offered "as is", "where is" unless otherwise noted herein, SELLER MAKES NO WARRANTIES OF ANY KIND WHATEVER, EXPRESSED OR IMPLIED, OR MERCHANT-ABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  All specifications and description of said goods are approximate only.  It is the Buyers responsibility to inspect the goods and ascertain if the specifications, description and condition of the goods conform to Buyer's requirements.

MACHINE USE AND SAFETY:  Buyer acknowledges that the goods described herein are preowned used GOODS WHICH WERE NEITHER DESIGNED NOR MANUFACTURED BY THE seller, nor has the Seller knowledge of,  or control over the prior use or misuse of said goods, nor does the Seller have knowledge or control over the future application of these goods by the Buyer.  It is the Buyer's (user's) responsibility to provide proper safety devices, equipment and instructions for any particular use and to take all necessary steps to conform to all federal, state or local government safety standards including OSHA. INDEMNIFICATION:  Buyer agrees to indemnify, hold harmless and defend Seller of and from any and all claims, liabilities and damages from any accidents or other incidents involving the goods described herein.

Also published on classifieds board.